Step 1. |
On the Home tab→Solids group, click one of the following buttons:
|
Step 2. |
Do one of the following:
|
Step 3. |
Draw or select an open or closed profile. Note: If you are using the Extrude command to construct a base feature, the profile must be closed. Click to define the side of the profile you want to add material to or remove material from. This step is skipped if the profile is closed. |
Step 4. |
Define the extent of the material you want to add or remove. |
Step 5. |
Finish the feature. |
Note:
The ends of an open profile are extended infinitely—an arc with open ends is extended to form a circle.
The Treatment Step on the command bar allows you to define draft and crown parameters to a protrusion or cutout feature.