Specifies that you want to apply bend relief to the source face from which the sheet metal feature is constructed. When you set this option, you can also specify whether the bend relief is round or square, and whether the bend relief applies to only the material adjacent to the bend or to the entire face.

This option is not available with the Transform to Synchronous Sheet Metal command.

Specifies that the internal corners contain square bend relief.

Specifies that the internal corners contain round bend relief.

Specifies the depth of the bend relief.

Uses the default value specified on the Options dialog box.

Specifies the width of the bend relief.

Saves the current settings as the default. Saved defaults will be used the next time you use this command. If you do not save the current settings as defaults, the previous default settings will be used.