A variety of enhancements were made to class fit dimensions in Draft, PMI and in sketches.

• New tolerance dimension formatting settings are available in the Tolerance Text group on the Text tab in the Dimension Style and Dimension Properties dialog boxes.

  Hole/Shaft

  Three separator types are available to specify the layout of class fit hole/shaft dimensions with tolerance.

  Use these options	To get this layout
  Separator	Vertical
  Space	Vertical
  Slash	Horizontal

  Position

  Three vertical tolerance text position options are available.

  Use these options	To get this layout
  Bottom	Tolerance aligned to the bottom of the dimension text.
  Center	Tolerance center-aligned with the dimension text.
  Top	Tolerance aligned to the top of the dimension text.

  Align to

  Two options are available to specify how to align the upper tolerance value with the lower tolerance value: by Decimal Point or by Sign.

  Use tolerance text size for combined tolerance text values

  A new check box specifies that the combined values are displayed using the tolerance text size entered in the Size box.

  Example:

  

• New class fit dimension display options are available when the Dimension Type is set to Class on the Dimension command bar or the Smart Dimension command bar.

  Fit
  Fit, tolerance only
  Fit with tolerance
  Fit with limits
  Fit Hole/Shaft only
  Fit Hole/Shaft, tolerance only
  Fit Hole/Shaft with tolerance
  User-defined (Any user-defined text is valid)