New options in the Drawing View Properties dialog box are available to change the hatching on cut faces in section views. You can adjust the angle and spacing of the fill style directly. New section views created from modified section views inherit the hatching overrides.

Previously, you could only adjust cut face hatching using the Draw In View command.

• When a section drawing view is selected, you can make interactive adjustments to the hatching on one or more individual part faces using the following new options on the Display tab (Drawing View Properties dialog box):

  • Spacing

  • Angle

• On the Edge Display tab (Solid Edge Options dialog box), you can use the following file level check boxes to specify that the hatch pattern in newly created section views is always differentiated on different part faces:

  • Automatically alternate hatch spacing in section views

  • Automatically alternate hatch angle in section views

• These check boxes are also available in the Drawing View Display Defaults dialog box when you edit a section drawing view. You can use them to override the file level options.

  Note:

  You can open this dialog box from the drawing view properties Display tab, using the Drawing View Display Defaults button . Previously, this dialog box was named Part Edge Display Defaults.