A number of enhancements were made to the Bolt Hole Circle command. Now you can:

• Create a bolt hole circle by specifying its diameter. The new creation option, By 2 Points, is available on the Bolt Hole Circle command bar.

• Create a bolt hole circle that is less than 360 degrees using the new Trim option on the Bolt Hole Circle command bar.

  

• Adjust the length of a trimmed bolt hole circle segment using the round edit handles displayed at either end.

  

• Locate the following new geometry types during bolt hole circle creation:

  • Arcs

  • Hidden lines

  Note:

  Center marks now are placed automatically on all bolt hole circle geometry.

For more information, see Place a bolt hole circle.